Application Instructions :(Please read general instructions)
Surface Preparation
:
Surface to be coated must be
structurally sound, dry, free from loose material. All surface contamination
must be removed. Grease and oil should be grit blasted or water jetted.
Deeper penetration must be removed by mechanical Means.
Mixing:
Contents of Resin and Hardener
should be thoroughly stirred individually to disperse any settlement which
may taken place during storage. The entire contents of Hardener should be
poured into Resin and the materials thoroughly mixed for at least 3 minutes
taking particular care to scrap the sides and bottom of the container.
Mechanical mixing using a slow speed (300-400 rpm) electric drill fitted
with mixing paddle is preferable. Follow mix ratio for part mixing.
Application :
Apply mixed materials with stiff nylon brush. The 1st coat must be firmly
applied and be well scrubbed into the surface. The 1st coating should be
allowed to become tack free, before applying the 2nd coat. No thinners or
solvents should be Added
